Lift Z axis in pause state

[wanderingtruckie (terry - oval lane creations)]

hi colin
just wondering if you or one of the other techs could look at my post

Lift Z axis in pause state

midway through a job, a small cut out piece , while being sucked out by the extractor , the tool managed to drive itself into said piece amazingly it didn’t break the tool of 3mm, i paused job turned off router , went into move panel / jog and tried to lift z axis to remove stuck piece , nothing happened tried position tab , entered a higher z position , than clicked go to z , no movement ? is it possible to manually lift Z axis while job is paused had an after thought could i create a cu…

and see if my crazy idea is possible for changing pause gcode