Lightburn 17.01 COMPATIBLE WITH A MOPA RAYCUS CURRENTLY USING EZCAD

LightBurn Hardware Compatibility Ruida controllers
1

HELLO I thought this would be a simple question. But, the fiber laser with a raycus source using ezcad can this laser be compatible with Lightburn.
Thank you for your answers in advance
If you need model it is a mopa JPT M7 debating this purchase because I perfer to use lightburn to ezcad
thank you again
Bob

2

if this runs EZCAD2 or EZCAD Lite it is compatible. Raycus is one of the supported fiber types.

If OmTech advertise this as working for LightBurn then it likely does. I haven’t seen any misadvertisements from them, at least as of late.

3

THANK YOU FOR YOUR REPLY. This laser is not from Omtech, however it is a chinese fiber laser I have not settle my personal debate on its purchase. I am also thinking about a Comaker b6, but it is up in price. Thank you again Bob

1 Like
4

I think the title of this thread, “omtech af 2028 need tech specs”, is causing some confusion.

5

Somebody fixed it.