Lightburn Camera Field of View

LightBurn Software Questions
1

I’m not sure I’m in the correct group. But, I just got a new laser and installed an 8MP120-W. I installed one previously on my old laser. So, I centered the camera inside the lid, and about 6 inches of the left side of the bed is cutoff. I moved the camera to the left, and while it captures more of the bed, it still shows wide right. I know it’s mounted correctly.

Any suggestions?

2

During the camera alignment calibration process, you set the scale size for the camera to capture your bed:

Did you use the camera selection helper tool to pick out your camera and determine your minimum mounting height?

3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.