I just got my xTool D1 last week and set it up with Laserbox and connected the xTool D1 to my wifi. Firmware is updated and then I purchased Lightburn, followed the instructions to connect the xTool D1 but it only give the option for a USB connection.
I want to connect via ethernet.
How do I connect my xTool D1 to Lightburn via ethernet?
LightBurn doesn’t support ethernet connection to xTool D1 or any g-code controller as far as I’m aware.
Does the xTool D1 even have an Ethernet port or is it wifi?
That would make it even harder if it didn’t have an ethernet connection.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.