just installed lightburn on a new laptop. i normally run a xtool d1pro 20w and just got an omtech 60w co2 laser. when i use my d1pro using the new lightburn software and frame my image, the engraving starts right of center about 1/4" and engraves upside down and mirrored. not sure what to do!! note that it engraves perfectly on the new omtech
You have your machine origin set incorrectly for the D1. The Omtech machine origin is right rear, I believe the D1 is left rear. This is changed in Device settings (Wrench & Screwdriver Icon).
2 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.