First time posting here. I’ve been using Lightburn for about 3 months now, since I got a 30 watt Raycus Fiber. I’m having an issue where Lightburn will freeze up when I start engraving a project. It will preview fine, then when I hit start it will freeze up. Clicking the mouse after this then causes the Lightburn Application to say “Not Responding”. I’ll also note that this does not always happen. It’s sporatic. But it seems to happen when I go from preview to start too quickly (Within 15 seconds or so) and only happens when I hit start. I’ve tried uninstalling and reinstalling the application. Any tips?