Lightburn homing problem

hello I just got my ortur set up with grbl and lightburn. However, it is giving me trouble when trying to home it.
exact msg reads:
“ALARM:8
Homing fail. Cycle failed to clear limit switch when pulling off. Try increasing pull-off setting or check wiring.”
I have increased pull-off setting up to 100 of its units and will move further along the x-axis but will not home properly. checked on grbl and it will home however if try moving it upwards or in diagonal it will not do it.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.