Lightburn is driving me crazy with the Tumblers

LightBurn Software Questions
1

First of all, my English is not the best, so please excuse any mistakes. Short story, I have a Xtool 10W D1 Pro. In the past I have done engravings on tumblers with quite good results. A few nights ago I did 3 of a large order, they turned out super nice with the letters in shiny silver. That night I turned off the Xtool and the laptop. The next day I cleaned the lens and started working again. I didn’t make any changes to the settings, nothing. But the result was horrible. I checked the settings several times but nothing different from the previous night. I always do tumblers with 2000 mm/min and 85% power. What could have happened to make the tumblers look so ugly?

Thanks,
I. Diaz.

1 Like
2

How did you clean the lenz ? did it go back the correct way.

3

As I usually do… a cotton q-tip with alcohol. Part of the things I did after the problems started was to replace the lens, just to rule it out. After a lot of testing I set the speed to 2000 mm/min and 100% power and managed to get close to the result I had before the event.

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.