# Lightburn keeps stopping in middle of a process

**URL:** <https://forum.lightburnsoftware.com/t/lightburn-keeps-stopping-in-middle-of-a-process/23641>\
**Category:** LightBurn Software Questions\
**Created:** [October 10, 2020, 7:32pm UTC](https://forum.lightburnsoftware.com/t/lightburn-keeps-stopping-in-middle-of-a-process/23641 "2020-10-10T19:32:01Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![bralwel](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/b/8491ac/32.png) [@bralwel](https://forum.lightburnsoftware.com/u/bralwel)\
**Post date:** [October 10, 2020, 7:32pm UTC](https://forum.lightburnsoftware.com/t/lightburn-keeps-stopping-in-middle-of-a-process/23641/1 "2020-10-10T19:32:02Z")

</div>

I am using Lightburn to make a tile picture that should take about 3hrs to burn. At the 41:26 mark it stops the process and then homes. This just started today. I’ve tried on 2 separate files and the same thing. I’m runnint an Ortur LM2 15W

---

<div class="post-metadata">

**Author:** ![LightBurn](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/lightburn/32/75577_2.png) [@LightBurn](https://forum.lightburnsoftware.com/u/LightBurn)\
**Post date:** [October 11, 2020, 1:15am UTC](https://forum.lightburnsoftware.com/t/lightburn-keeps-stopping-in-middle-of-a-process/23641/2 "2020-10-11T01:15:09Z")

</div>

If it’s re-homing, that’s a USB disconnection / reconnect, which is most likely caused by a loose cable or port connection, or possibly a power brownout. I would check the USB connection is not loose at all on either the Ortur side or the computer side, and the power connection is secure as well.

---

<div class="post-metadata">

**Author:** ![bralwel](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/b/8491ac/32.png) [@bralwel](https://forum.lightburnsoftware.com/u/bralwel)\
**Post date:** [October 11, 2020, 8:20pm UTC](https://forum.lightburnsoftware.com/t/lightburn-keeps-stopping-in-middle-of-a-process/23641/3 "2020-10-11T20:20:40Z")

</div>

Thanks. I’ve plugged in to a different USB port, rechecked all connections and re-installed Lightburn. So far so good. It’s got 5 hours on it today.

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [November 10, 2020, 8:20pm UTC](https://forum.lightburnsoftware.com/t/lightburn-keeps-stopping-in-middle-of-a-process/23641/4 "2020-11-10T20:20:42Z")

</div>

Closed on November 10, 2020, 8:20pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
