I have a Sculpfun S9 laser and an Eleksmaker A3 pro.
When running a job all works well and the job finishes but in the console it shows that the job is still connected and when I have to eventually close Lightburn to force disconnection it will state that there is still a job streaming. I have to do this after every job and this was the situation with the Eleksmaker for a long time and now my new Sculpfun is having the same issue with Lightburn. Is there settings that must be adjusted or what? Just a side note is that I have to also pull out the usb cable to reset the system as well for a fresh job.
Any assistance with this issue will be most welcome
Sean Goldie