Lightburn not saving power settings and modes when upon reopening

Hi everyone,

More help needed. I just designed a file and got it where I wanted it to be. This time I recorded all the layers and their settings in my notebook. Went back to the file at a later date and found that the layers were in numerical order, except for COO, which was on top of the layer list. Before closing it was on the bottom for the cut layer. Is this by default and can you change this with a different setting? Also, one layer had the mode wrong, was fill, it changed it to line and the maximum and minimum power settings were changed. Any reason why this would occur?

Thank you,

Jim

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.