Lightburn not storing settings from diffrent lasers

Hi everyone.

I have just added a CO2 laser with a monport GRBL control board into lightburn.
I have two lasers added a diode laser and the new CO2, when i try to swap between lasers the diode laser doesn’t retain it’s settings and opens with the new settings from the CO2 laser and i have to manyally change the settings back in the device settings tab.
Any help with this will be greatly appreciated.
Thankyou

I am not sure if I’m following what is happening here. Please illustrate with screen captures, showing what you are observing and steps taken when you see this happening. :slight_smile: