Lightburn, Ruida 6445G, 15.01.22 Firmware and a Rotary

[JTR (Tyler Raps)]

Try following the exact sequence from this post:

Ruida 6445 and Rotary

Success! The magic bullet was setting the origin on the Ruida. This is what works for me with V15.01.22 and the rotary connected to the U axis. Enable rotary in Lightburn Use ‘Start from current position’ in Lightburn Jog x and y on the Ruida to move the laser to the required starting point on the work Press ‘Origin’ button on Ruida Send job from Lightburn to Ruida Run job by pressing start button on Ruida. Step 4 is what I wasn’t doing. Everyone else may have known to do that, but I didn’t! …