Lightburn Start and End Delay do not work past 42 Seconds

[Lcamyers (Chris Myers)]

If I set the delay higher than 42 seconds, it acts like it is doing a modulo function and only delaying by the remainder amount. Entering 60 gets me about 18 seconds of start delay, 43 gets a near instant start. 42 works.

Any insight? Using a Ruida RDC644 on a Thunder Laser.

Anyone else able to get it to work to 60 seconds?

[berainlb (PY)]

I don’t have an answer for you but that could explain the behavior in this post.

End delay past 60 seconds? Bug?

I noticed the end delay can be set to 60secs, which is great, however, when timing it, it waits for about 17 seconds then finishes the cut. I can’t set it longer than 60secs, so its always waiting about 17 seconds afterwards. I’d like to set it much longer, about 1:30/2 minutes, so that I’m sure the smoke is cleared out of the laser each time.