LightBurn stops burning and "homes" before the job is complete

What would cause LightBurn to not only stop but to also Home before the job is done? It has always gone back to the start position not Home when a job finishes.


You are telling it that the finish position is 0.0 , 0.0

When the job is done and it goes to home I can live with that or change it. But I cannot understand why it’s homing before the job is done. The attached photos show what is happening. Don’t mind the garbage in the one. Alter the laser shutdown it became a test piece.


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.