LightBurn v2.0.00-RC4 Release Candidate

[berainlb (PY)]

Note that Cut Shapes bug from RC3 persists here:

LightBurn v2.0.00-RC3 Release Candidate

I’m noticing a problem with Cut Shapes behavior under specific conditions. The resulting cut shape does not match expectations. Before: [image] After: [image] The resulting cut shape doesn’t match the semi-circle expected and instead results in a quarter circle plus what looks like 2 corners of orphaned nodes. Similarly, this setup results in what looks like no change: [image] After: [image] It seems that these issues occur any time that the center of an ellipse intersects with any…

This may be expected as I don’t see an obvious bug fix reference in the notes but wanted to make sure it was on the radar.