# Lightburn will not connect to Omtech 30W Galvo Fiber Laser

**URL:** <https://forum.lightburnsoftware.com/t/lightburn-will-not-connect-to-omtech-30w-galvo-fiber-laser/191636>\
**Category:** LightBurn Software Questions\
**Tags:** galvo, omtech\
**Created:** [August 3, 2026, 5:47pm UTC](https://forum.lightburnsoftware.com/t/lightburn-will-not-connect-to-omtech-30w-galvo-fiber-laser/191636 "2026-08-03T17:47:39Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![DaveIannone](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/d/ac91a4/32.png) [@DaveIannone](https://forum.lightburnsoftware.com/u/DaveIannone)\
**Post date:** [August 3, 2026, 5:47pm UTC](https://forum.lightburnsoftware.com/t/lightburn-will-not-connect-to-omtech-30w-galvo-fiber-laser/191636/1 "2026-08-03T17:47:39Z")

</div>

I have been using Lightburn for quite some time with a C02 laser, and I can’t get my new Omtech 30W Galvo Fiber to connect to lightburn

it lists Galvo as one of the lasers under LICENSE MANAGEMENT

Thanks,

Dave I

---

<div class="post-metadata">

**Author:** ![jkwilborn](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/jkwilborn/32/63089_2.png) [@jkwilborn](https://forum.lightburnsoftware.com/u/jkwilborn)\
**Post date:** [August 4, 2026, 8:43pm UTC](https://forum.lightburnsoftware.com/t/lightburn-will-not-connect-to-omtech-30w-galvo-fiber-laser/191636/2 "2026-08-04T20:43:04Z")

</div>

The EZCad software doesn’t use the same driver that Lightburn uses. Did/can you double check that?

[![](https://img.youtube.com/vi/lGO9IsJbN14/maxresdefault.jpg "EASY! Swap Between LightBurn and Ezcad FAST") ](https://www.youtube.com/watch?v=lGO9IsJbN14&t=1s)

Good luck.

😺

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [September 3, 2026, 8:43pm UTC](https://forum.lightburnsoftware.com/t/lightburn-will-not-connect-to-omtech-30w-galvo-fiber-laser/191636/3 "2026-09-03T20:43:49Z")

</div>

Closed on September 3, 2026, 8:43pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
