Lighturn and RDworks

[LightBurn (Oz)]

You most likely didn’t use the same setting - A very common mistake is ignoring the “min power” value. In RDWorks you’ve likely set it the same as the “max power” value, but in LightBurn you’ve probably left it alone.

Read here:

Ruida / LightBurn won't cut below 10mm/s

I was using 0.09.01 and then updated to the 0.09.02 Win64 file. I was running the scan power test grid which worked great. I wanted a cut grid so I changed everything form Scan to Line and changed the speeds range to 70-10mm/s and left power at 10-100. When it uploaded to the laser and ran the file it reached the bottom row, which was 10mm/s and traced the boxes but didn’t mark the wood. After testing several different things I tried a speed of 11mm/s and it worked fine. I tested down to 5…