I have noticed that the line, on the fill+line sometimes overshoots (photos below to explain)
I don’t think this is a hardware issue because I engraved a 9 letter word and only 2 letters had this issue. The X axis belt is tensioned correctly without any slop.
This is a hardware issue known as backlash, but can be addressed with the ‘Scanning Offset Adjustment’ found on the ‘Device Settings’ page. I would suggest reading through this: https://github.com/LightBurnSoftware/Documentation/blob/master/ScanningOffsetAdjustment.md#scanning-offset-adjustment
It looks like your system needs a couple entries in the scanning offset table.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
