LO-X7 (AWC 708) not connecting Ethernet

I had to reset my laptop recently, and now I cannot get my AWC 708 lite to connect via ethernet again. LO’s Raycam connects fine, but no matter what I do, Lightburn can’t see it. I have even tried a desktop switch, and still nothing. I can ping it, but Lightburn can’t see it. About to reinstall lightburn to see if that helps. Has there been any other report of this issue?

No, I haven’t heard of this one before. Did the IP address change, by chance?

No, the IP was the same. Refreshing the lightburn install did nothing to help as well. Currentlt I have dsp set to 192.168.1.100, and the laptop set to 192.168.1.110. Dsp pings without loss.