# Looking for Ballpark Settings to Cut Metal Business Cards on ComMarker B4 20W Fiber Laser

**URL:** <https://forum.lightburnsoftware.com/t/looking-for-ballpark-settings-to-cut-metal-business-cards-on-commarker-b4-20w-fiber-laser/176307>\
**Category:** Community Laser Talk\
**Created:** [July 25, 2025, 6:59pm UTC](https://forum.lightburnsoftware.com/t/looking-for-ballpark-settings-to-cut-metal-business-cards-on-commarker-b4-20w-fiber-laser/176307 "2025-07-25T18:59:42Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![tcbeaton](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/tcbeaton/32/108815_2.png) [@tcbeaton](https://forum.lightburnsoftware.com/u/tcbeaton)\
**Post date:** [July 25, 2025, 6:59pm UTC](https://forum.lightburnsoftware.com/t/looking-for-ballpark-settings-to-cut-metal-business-cards-on-commarker-b4-20w-fiber-laser/176307/1 "2025-07-25T18:59:42Z")

</div>

I know this is an open-ended question, based on the individual laser and material, but I’m just looking for a starting point.

Along with etching a metal business card, which I have successfully done, I want to fully cut a design out of the card leaving a hole.

I have attempted many different speed, power, frequency, and number of passes combinations, but none seem to cut all the way through the card.

Is this possible with a 20W fiber laser, and if so, do you have any ballpark settings or tips I could start with to figure out the actual settings that would work for my set up?

Thanks for the help!
