Chrik
(Christian Chauvin)
September 8, 2020, 7:22pm
1
Hi, somebody know why, when I try to cut using a speed below 10mm/s, the power drop to 4mA whatever the power I put in Lightburn? 10mm/s or higher, can go up to 34mA but 9mm/s, nothing?
Using the control panel, I can do whatever I want, 1mm/s at 99% if I want.
Thanks.
Rick
(Technical Evangelist)
September 8, 2020, 7:51pm
2
Chrik:
speed below 10mm/s
Using the search feature found at the top-right of each page, I found this:
This isn’t a LightBurn issue, but a Ruida one that’s quite common.
There’s a controller setting called “Start Speed” that defaults to 10mm/sec. At that speed, power starts ramping up from Min Power to Max Power. Cutting at or below that speed means you’re using Min Power only, so if you’re cutting slow, set both Min and Max power the same and you’ll have no issues.
1 Like
Chrik
(Christian Chauvin)
September 8, 2020, 7:53pm
3
Awesome, thanks you so much Rick!
1 Like
system
(system)
Closed
October 8, 2020, 7:53pm
4
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.