I have a NEJE, switched to Lightburn because it was a recommended product. I have it loaded, I am CAD trained so I can figure out design, art, symbols, etc. I can do quite well at this.
then I want to engrave. Problems getting it to drive my NEJE on a more than unregular basis. Drop the NEJE out, engraves 3 logos, then lost device. Can’t stop device busy action.
Just what did I miss on getting the results my BFF gets on his device? Any help of tutorial would be appreciated.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.