Looking for help in resetting my Machine settings. I was trying to calibrate my x and y axis settings and now my machine is all out of whack. Is there some way to reset the controller to default/factory settings? For both x and y I updated the requested 50mm and actual distance 49.45. I know it’s not a big difference, but I seem to have gone wrong somewhere and can’t get the laser to align correctly now.
Thanks for any help.
$$
$0=10
$1=25
$2=0
$3=0
$4=0
$5=1
$6=0
$10=1
$11=0.010
$12=0.002
$13=0
$20=0
$21=1
$22=1
$23=3
$24=300.000
$25=3000.000
$26=250.000
$27=1.000
$30=1000.000
$31=0.000
$32=1
$37=1
$100=321.968
$101=80.554
$102=80.000
$103=100.000
$104=100.000
$105=100.000
$110=6000.000
$111=6000.000
$112=6000.000
$113=1000.000
$114=1000.000
$115=1000.000
$120=1000.000
$121=1000.000
$122=1000.000
$123=200.000
$124=200.000
$125=200.000
$130=410.000
$131=400.000
$132=200.000
$133=300.000
$134=300.000
$135=300.000
ok
I believe default for all these should be 80. I suspect your X axis is running 4x too small.
1 Like
Thanks so much for the quick reply. I have updated those settings and all working again.
Don’t know where I went wrong.
Thanks again.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.