Machine quits mid program and goes into alarm 3
G1 X0.0276S0
G1 X0.0393S370
ALARM:3
Reset while in motion. Grbl cannot guarantee position. Lost steps are likely. Re-homing is highly recommended.
On or near line 7056:
Job halted
Stream completed in 7:12
ok
Grbl 1.1f [‘$’ for help]
[MSG:‘$H’|‘$X’ to unlock]
$X
[MSG:Caution: Unlocked]
ok
Desperate to finish something
There’s likely something higher up in Console that indicates that condition that actually raised the alarm. Search for it and copy/paste results here.
I had copied and pasted more results from another hang-up but must have done something wrong when sending it. Now it won’t reproduce. So, I guess, until or if, it happens again I’m all set. Thanks for looking into it for me.
Bruce
I have a Boss HP3655, that acts goofy at times. Like yesterday. Worked on a file in Photograv to resize and kick up dpi. When loading into lightburn and running the file it frames good but when I try to run it. It goes to bottom where it is going to start and does a single sometimes 2, 3 scans then stops on either side. Have to reboot machine to make it go to home. Restart with same results. Trying to etch on back of a mirror,???
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.