FINALLY!!! Thank you so very much!
I still don’t get it where it went wrong but homing goes well, coördinates on the screen grid is good, movement in the desired direction, origin bottom left with coördinates 0,0 and top right 397,382 (because the 3mm bounce back)
The X direction on the touchscreen is still inverted but that doesn’t matter much to me. Probably not fixable combined with a good working Lightburn unless the firmware is fixed with the X direction. I thought of changing the wiring on the X motor but that doesn’t help, then the touchscreen would work but Lightburn would be inverted again. Looks like a difference in interpretation of direction on the X between touchscreen compared to lightburn. If there is a way to swap direction in Lightburn without changing $parameters, it could work completely; then I need to change the X direction in the configurarion again (and the homing). If there is a way to change direction in some way without changing the controller configuration, please let me know.
I’ll post my currently working settings for future readers.
$0=10
$1=25
$2=0
$3=0
$4=0
$5=1
$6=0
$10=0
$11=0.010
$12=0.002
$13=0
$20=0
$21=1
$22=1
$23=0
$24=300.000
$25=1500.000
$26=250.000
$27=3.000
$28=1000.000
$30=1000.000
$31=0.000
$32=1
$38=0
$40=1
$100=80.000
$101=80.000
$102=80.000
$103=100.000
$104=100.00
$105=100.000
$110=6000.000
$111=6000.000
$112=6000.000
$113=1000.000
$114=1000.000
$115=1000.000
$120=500.000
$121=500.000
$122=500.000
$123=200.000
$124=200.000
$125=200.000
$130=400.000
$131=385.000
$132=80.000
$133=300.000
$134=300.000
$135=300.000
Thank you so very much