Missing lines in wood etching

[MikeyH (Mike Hembrey)]

Looks mechanical.
Belts? Check
Lens? Clean.
Set screws? What set screws?

Vector Art burn skipping lines

Hello, I have a piece of vector art that I have brought into Light Burn as an image and as a vector. The image version burns perfectly but the vector version of the same art skips lines, and I haven’t been able to figure out what’s causing that. I have noticed that it tends to happen in circles, almost like the start and end position of the circle don’t quite meet. Here are some details about the set up I am using: Otur 20w, firmware v1.34, Light Burn 0.9.16, GRBL-M3 “1.1e or earlier” profile …