Move bed (z axis) within lightburn

[MTNeedles (Mike Benson)]

Hello,

I have 2 lines I want cut (vector). Red and blue
the Red line I want to vector cut 3mm out of focus (move bed away from cutting head 3mm)
the blue line I want to vector in focus.

Can I automate this process in lightburn? In other words, set the red line to lower the bed 3mm and The blue line to raise the bed 3mm.
Is this supported by ligntburn?

My work around is to run the red line manually adjust the bed and run the blue line.

thank you

[LightBurn (Oz)]

In Edit > Device Settings, turn on ‘Enable Z’, ‘Relative Z Moves only’, and ‘Optimize Z Moves’.

Then, in your cut settings, you can specify a Z offset for each layer if you wish.

[MTNeedles (Mike Benson)]

will give it a go… thank you