MPCNC 5W Diode, not turning off during travel

Morning,
Loving Lightburn but I’m running into the issue of the laser not turning off during travel. The Smin value is at 10, grayed out and I cant turn it to 0, my Smax is set to 255. I have my settings set to diode, but cant figure out how to get the laser to shut off during travel during “line” cuts.

Any suggestions?

Thanks
Keith

Is the laser firing at full power during travel, or is it dimmed (S10)?

The “SMin value is at 10, grayed out” - what are you referring to here?

The most common cause of this is not having ‘Laser Mode’ enabled ($32=1 if you are using GRBL 1.1f).

Posted in Marlin, so probably not GRBL.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.