My laser has no effect.only the blue light. Has contact with the laser from pc.
Hi Henrik, Welcome to LightBurn!
I was at about the same place a month ago and my speed settings were messed up and I couldn’t get decent engraving or marking. The controller software cuts power on overspeed conditions and the defaults caused me some confusion starting out. Can you go to Console and enter $$ to dump the device settings and copy/paste that string of information here?
It’ll help folks here get you going.
Kind regards,
John
1 Like
$0=5.0
$1=100
$2=0
$3=2
$4=7
$5=7
$6=1
$10=2047
$11=0.050
$12=0.002
$13=0
$14=6
$15=0
$16=1
$17=4
$18=0
$19=0
$20=1
$21=1
$22=43
$23=7
$24=600.000
$25=3000.000
$26=100
$27=3.000
$28=0.100
$29=0.0
$30=1000.
$31=0.
$32=1
$33=1000.000
$34=0.000
$35=0.000
$36=100.000
$37=0
$39=1
$40=1
$41=0
$42=1
$43=1
$44=3
$45=4
$46=0
$56=1.000
$57=1800.000
$58=395.000
$59=6000.000
$60=0
$61=0
$62=0
$63=3
$64=1
$65=0
$259=0
$260=70
$261=70
$262=230
$263=30
$264=0
$265=100
$267=0
$100=80.000
$101=80.000
$102=400.000
$110=10200.000
$111=10200.000
$112=1200.000
$120=2200.000
$121=1800.000
$122=2200.000
$130=400.000
$131=400.000
$132=50.000
ok
that’s your problem, maybe a mistake, put them to 1500
I’m curious about these. I’ve never seen these values end with a decimal point. $30 affects power levels so an error here could affect output. Not sure if the ‘.’ is a problem though.
1 Like
How can I change $30 and $31
Henrik
from machine settings, you set the values then click on write
This may be worth review.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.