I have a Jinsoku 50w laser. I have my project all set up and and can’t get my laser to fire. I’ve tried different speeds and power settings but no luck.
Can’t find this on the Internet.
We can’t help much if we don’t know how your machine works. I did find some by Jinsoku, but there were 5.5W models, apparently grbl based controller.
Can you supply a link…
After much research, I found the problem and am able to engrave again.
and was? cause if happens to another user there is the solution…
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.