Hello. I have this problem from today. My laser is moving very slow 5cm for 20sec and this problem is only with LightBurn. I tried laserGBRL and there everything seems fine. Thanks in advance.
post your settings
$0=10
$1=25
$2=0
$3=3
$4=0
$5=0
$6=0
$10=1
$11=0.010
$12=0.002
$13=0
$20=0
$21=0
$22=1
$23=1
$24=250.000
$25=1000.000
$26=250
$27=1.000
$30=1000
$31=0
$32=1
$100=80.000
$101=80.000
$102=80.000
$110=4000.000
$111=4000.000
$112=4000.000
$120=200.000
$121=200.000
$122=200.000
$130=810.000
$131=460.000
$132=150.000
In LightBurn, please capture the information in the Move window (with a screen capture or snip tool) and post it here. I believe that you might be saying that the starting or traverse speed is slow. The settings there may offer us some insight.
If it’s not about the starting - traverse speed I’d like to look at the requested speed in the Layer in question. Double click the layer you’re engraving in the Cuts / Layers window and capture that pop-up as well.
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.