Post issue previously, about burn intermitantly stopping during project. Why is this happening? I have to keep stopping the job and go to preview window to restart from current position, it burns for a little time then stops again! Please help!
This is what message I get in console,
Starting stream
Layer C00
o�H�ok
�ok
�ok
�ok
o�H�ok
�ok
Job halted
Stream completed in 23:01
Grbl 1.1f [’$’ for help]
ok
Starting stream
Layer C00
o�H�ok
�ok
o�H�ok
�ok
Job halted
Stream completed in 14:24
o�H�
Grbl 1.1f [’$’ for help]
ok
This may be because the baud rate is inaccurate. I arranged for NEJE engineers to provide a 9600 firmware to try. Please follow the neje wiki service. You can find the latest firmware switcher version 3.0 at present.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.