# NEJE Master 2 rotary and z axis setup

**URL:** <https://forum.lightburnsoftware.com/t/neje-master-2-rotary-and-z-axis-setup/22376>\
**Category:** LightBurn Hardware Compatibility\
**Created:** [September 19, 2020, 5:08pm UTC](https://forum.lightburnsoftware.com/t/neje-master-2-rotary-and-z-axis-setup/22376 "2020-09-19T17:08:11Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Tangyduck](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/t/3ab097/32.png) [@Tangyduck](https://forum.lightburnsoftware.com/u/Tangyduck)\
**Post date:** [September 19, 2020, 5:08pm UTC](https://forum.lightburnsoftware.com/t/neje-master-2-rotary-and-z-axis-setup/22376/1 "2020-09-19T17:08:11Z")

</div>

Hi,  
When I heard that lightburn would work with NEJE Master 2, I took the plunge and bought a NEJE master 2. I already have a k40 work in progress (lights, air, cohesion3d etc.) but I liked the physical accessibility of the NEJE. I’ve set about making a framework to supplement the laser. Hardware wise, I have lights, air assist, rotary axis, camera and z axis (for focus).

Although the NEJE documentation and a few posts here make mention of rotary and z axis, there is little explanation of how to set them up. When I look at my NEJE, the Z axis connector on the back of the PCB is already populated and has a five pin connector whose wires are all the same colour and I can’t find a pinout.

Has anyone had any joy in this area? And to just be cheeky, is there an output for air assist? I ask as I’ve seen it mentioned in lightburn. Any help would be very much appreciated - I put quite a lot of work into the frame - shame not to be able to put it to complete use.

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [October 19, 2020, 5:08pm UTC](https://forum.lightburnsoftware.com/t/neje-master-2-rotary-and-z-axis-setup/22376/2 "2020-10-19T17:08:13Z")

</div>

Closed on October 19, 2020, 5:08pm UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
