I have set up a camera (8mp) on my laser it is working perfectly and the alignment is great but not all of the image is being used and I cannot see the left-hand 150mm of the bed. The camera field of view goes from outside the bed height (top & bottom) and from outside the left-hand side to approx 200mm in from the right-hand side. The camera is intentionally offset to the left as I cannot get the full width in and the left side is the most important for me.
Any suggestions?
Thanks
Edward
The intentional offset is what’s causing the problem. LightBurn produces an image that is anchored to the center of the workspace, and the math is tricky enough as it is.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.