# Offset / kerf when fitting one cut out into another

**URL:** <https://forum.lightburnsoftware.com/t/offset-kerf-when-fitting-one-cut-out-into-another/113484>\
**Category:** LightBurn Software Questions\
**Created:** [October 15, 2023, 5:51pm UTC](https://forum.lightburnsoftware.com/t/offset-kerf-when-fitting-one-cut-out-into-another/113484 "2023-10-15T17:51:36Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![ednisley](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/ednisley/32/40455_2.png) [@ednisley](https://forum.lightburnsoftware.com/u/ednisley)\
**Post date:** [October 15, 2023, 8:42pm UTC](https://forum.lightburnsoftware.com/t/offset-kerf-when-fitting-one-cut-out-into-another/113484/3 "2023-10-15T20:42:52Z")

</div>

> [@Nige](#):
>
> how do i work out how much material my laser is burning away ?

A kerf measurement tool may help:

> [@Kerf Offset test: with built-in vernier scale for accuracy, no tools required!](https://forum.lightburnsoftware.com/t/kerf-offset-test-with-built-in-vernier-scale-for-accuracy-no-tools-required/98333):
>
> There has been a bit of a flurry of marquetry lately on the forum, and it prompted me to make a tool to help calculate kerf offset accurately and easily, while using minimal material: I was inspired by @jkwilborn’s [tool](https://forum.lightburnsoftware.com/t/marks-bumps-from-laser-refracting-off-honeycomb-laser-bed-is-that-a-thing/58558/4), but I added a [vernier scale](https://en.wikipedia.org/wiki/Vernier_scale) to make it easier to measure, without needing calipers! Just cut it, slide it, and calculate your kerf. Here’s the file: [Kerf Test with Vernier Scale.lbrn2](https://forum.lightburnsoftware.com/uploads/short-url/sgSzZNLnuzCgfSmvnT5XXs5SOFj.lbrn2) (2.4 MB) I’d love any feedbac…

You can find other tools using the same idea, but the general idea is to measure several cuts at once, then find the average to reduce the error.

You can apply the entire kerf width to one part or half to the part on each side of the cut. It’s easy to get the setting wrong, so practice on scrap before spinning up the irreplaceable veneers.

---

_[View the full topic](https://forum.lightburnsoftware.com/t/offset-kerf-when-fitting-one-cut-out-into-another/113484)._
