OLM ESP PRO V1.2 (Emergency Stop Switch Engaged)

[christinoccs (Cesar)]

Hi JohnJohn

I already bought a OLM ESP PRO V1.2.A I am building an cilinder engraver machine, shows this message (the ERROR message showed when I tried to make a square frame)

Waiting for connection…
Port opened, waiting for response.
ok
Starting stream
error:9
On or near line 0:
Stream completed in 0:00
error:9
error:9
error:9
error:9
error:9
error:9
error:9
error:9

And in laser GRBL shows this :
Ortur Laser master 2 Pro S2 Ready!
OLF:OLF 185.
OLH:OLM_ESP_PRO_V1.2.
OLM: GENERAL.
[MSG: Emergency Switch Engaged.]
[MSG: Flame detector Inactive. Lum…
Grbl 1.1f [;:['$´ for help]
[MSG: ´$H´´$H´to unlock]
$X Emergency stop engaged
[MSG: Emergency Switch Engaged.]

[OrturTech (Gil)]

A firmware will be needed for sure but first do this
Reach for big red button → Hold rotate clock wise it will pop up

In console, after connection
$RST=*
press enter
When machine responds with MSG: Restoring defaults
Tap reset, → power machine again

[JohnJohn (John Johnson)]

It looks like Gil has this well in hand.

I’ve taken the liberty of moving your post to it’s own thread as your error message was clearly stated and the resolution of this issue may be swift, clear and of benefit to others.

Thanks Gil!