Trying to get my OMG fiber going. It is a 50W from 2021. I am unsure of the workflow to get this going. I loaded the driver (I think) and the device manager shows a JBZ device and when I disconnect the USB it goes away, so I know it is the right device. I have a OMTech and it was easy, but LB isn’t finding this one. I have restarted everything with no joy. I see references to EZcad in setup videos, but I don’t see how this fits in. This is also running on a separate PC so there is no conflicts etc. I have a Pro license of LB on the PC as well. I just need a nudge to get going. TIA.
There is a lot of good information in the LightBurn docs page on the driver install for the BJJCZ cards, including how to ensure you have the correct driver loaded:
This looks like exactly what I am seeing. I will try this and report back. Thanks so much for pointing me in the right direction. I should have known that Jason and the LB folks would have stellar documentation.
That was exactly what it was. I thought I had installed the EZCAD2 driver, but apparently didn’t Went back and installed and now LB is connected to my laser. I didn’t have the EZCAD files from the laser so I DL’d EZCAD2 from the manufacturer site and then imported the mark7 file. I have am not sure what the “X and Y” is of my laser, but I am getting there. Watching videos from LB and such, thanks for the help so far!
2 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.