When I orgin frame …
the laser frames crooked. It moves over 2 inches from my start position.
I’ve never seen it do that before.
- What mode is ‘Start From’ in?
- Which version of LightBurn?
- Do you have a pointer offset value entered in your device settings?
- What type of controller?
It was fine until I did the last update.
I’ve it since sept 2019 and no problems until now. I got 0.9.10. Rudra controller.
The other questions you have I dont understand. I don’t know a whole lot about LB.
It only does it in half tone
Can you show a picture of what your file looks like?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.