I received my Laser Master 2 a few days ago. Got it put together, upgraded the firmware, and installed LightBurn. When trying to burn the test file, the unit moves like it’s going to engrave, I can hear the fan on the laser engage, as well as the indicator light on the top of the laser module, but no light coming out of the laser. Any tips or insight to troubleshooting will be greatly appreciated. Console output of the config is as follows:
$0=20
$1=50
$2=0
$3=0
$4=0
$5=0
$6=0
$10=1
$11=0.050
$12=0.002
$13=0
$20=1
$21=1
$22=1
$23=7
$24=600.000
$25=3000.000
$26=100
$27=2.000
$30=1000
$31=0
$32=1
$33=250.000
$100=80.000
$101=80.000
$102=80.000
$110=9000.000
$111=9000.000
$112=9000.000
$120=2200.000
$121=1800.000
$122=2500.000
$130=400.000
$131=430.000
$132=1.000
ok