Just got the Ortur Master Laser 2. Everything was working fine then today all of a sudden it couldn’t finish a burn and circles were wobbly. Also would not return home. Received the following: error:9
G-code locked out during alarm or jog state. How can I fix this and get the laser working again? THanks!
Now the laser is no longer returning Home.
Appears the laser motor axle is rotating but the track wheel is not.
You may get faster responses from the Ortur support site. 
Are your home switches working properly? Make sure the cord isnt getting caught between the home switch, and check to see that laser moves freely with it off, then rehome it and make sure cords arent getting caught.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.