Hello everyone. I seem to be haviing an iissue with my OLM 2 Pro and cant seem to find a solution.
a. Recently replaced the motherboard and installed the most recent firmware OLF 187.
b. I ordered and installed the Ortur Extension kit, it was a pain but everything checks out fine and seems to be working properly. Once I powered u my laser I checed the setting and reinstalled the laser using Lightburn changing the Y and X axis area to match the laser extension. So far so good.
c. While attempting to burn a reference grid i receive an error message and cannot seem to get past it. The laser is attached to a peice of MDF sitting on top of my table, I do not have any strong light and zero movement.
Ortur Laser Master 2 Pro S2 Ready!
OLF:OLF 187.
OLH:OLM_ESP_PRO_V1.2.
OLM:GENERAL.
[MSG: Warning: Flame Sensor Disabled by User OverRide]
[MSG: Flame detector active,Ambient infrared value:55]
Grbl 1.1f [‘$’ for help]
[MSG:‘$H’|‘$X’ to unlock]
[MSG:Caution: Unlocked]