Output not accurate to vector

I have just started using Lightburn with my Workbee CNC and 6w Optlaser

I then imported a dragonfly vector into Lightburn, exported Gcode to Workbee.

I have noticed there are several inaccuracies in the output. Some of these include the eyes of the dragonfly and gaps in lines.

I have tried running this at half my initial speed, reduing from 200 mm/sec down to 100 mm/sec. I am still having the same problem.

Any suggestions?



Do you mind ‘dropping’ the .lbrn2 file here for us to examine…


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.