# Oval Circles (kinda) when engraving. Why?

**URL:** <https://forum.lightburnsoftware.com/t/oval-circles-kinda-when-engraving-why/118804>\
**Category:** Community Laser Talk\
**Created:** [December 1, 2023, 4:47pm UTC](https://forum.lightburnsoftware.com/t/oval-circles-kinda-when-engraving-why/118804 "2023-12-01T16:47:42Z")\
**Posts on this page:** 1\
**Showing post:** 99

<div class="post-metadata">

**Author:** ![jkwilborn](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/jkwilborn/32/63089_2.png) [@jkwilborn](https://forum.lightburnsoftware.com/u/jkwilborn)\
**Post date:** [June 12, 2024, 5:06pm UTC](https://forum.lightburnsoftware.com/t/oval-circles-kinda-when-engraving-why/118804/99 "2024-06-12T17:06:55Z")

</div>

That looks like it reads 0.204 but I can’t tell the units…

There is a nicer tool that @BillieRuben built … it has a vernier caliper built in… You should get the same results either way.

> [@Kerf Offset test: with built-in vernier scale for accuracy, no tools required!](https://forum.lightburnsoftware.com/t/kerf-offset-test-with-built-in-vernier-scale-for-accuracy-no-tools-required/98333):
>
> There has been a bit of a flurry of marquetry lately on the forum, and it prompted me to make a tool to help calculate kerf offset accurately and easily, while using minimal material: I was inspired by @jkwilborn’s [tool](https://forum.lightburnsoftware.com/t/marks-bumps-from-laser-refracting-off-honeycomb-laser-bed-is-that-a-thing/58558/4), but I added a [vernier scale](https://en.wikipedia.org/wiki/Vernier_scale) to make it easier to measure, without needing calipers! Just cut it, slide it, and calculate your kerf. Here’s the file: [Kerf Test with Vernier Scale.lbrn2](https://forum.lightburnsoftware.com/uploads/short-url/sgSzZNLnuzCgfSmvnT5XXs5SOFj.lbrn2) (2.4 MB) I’d love any feedbac…

😸

---

_[View the full topic](https://forum.lightburnsoftware.com/t/oval-circles-kinda-when-engraving-why/118804)._
