Overlapping shapes and text

Installed new mini gerbil 3 MG3 board on my new Chinese laser which had Moshi board and its own software which was cutting and engraving fine .
Downloaded the latest version of lightburn trial as the MG3 supports light burn and tried few cuts of circle ( passes are fine) however i see every time i click start , the circle is overlapped slightly , i tried playing around current / user and absolute coordinates , i see every time i tried the circle is either overlapped or starts cutting 1 below the other. i chose circle to make it easier.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.