layering!
I set up some circles and the center circle is a mask for a photo. I set up the photo first then the mask circle then the rest of the circles. For some reason the machine is not engraving the sidenofnthose circles. I have reset up the design and still doing it. I have run other things so I know the laser is working
Need more information - what settings did you use for the circles? If you didn’t set your Min Power value, and those were run as lines, that could be the issue. It’s also possible that it’s a mirror alignment issue, but that would be less likely, based on the position of the dead spot.
Well, that was it, the minimum value was zero, I adjusted that and now it cut my circles out 
. So now I can go from there
