Pro is not cutting or engraving correctly

[Pete.IRL (Peter O D)]

Terry

I found this when I searched Topics for “Reversed engraving”…It’s about Work Origin, hope its relevant.

Engraving reversed

I loaded a file into my AtomStack Swift 7W and it had a “text” name in the design. When I ran the file it engraved and filled nicely. I then loaded the same file into Lightburn and ran it but for some reason the name engraved reversed (like in a mirror). I used the mirror tool and it engraved the right way but the rest of the engraving was a little bit messy. Why would that happen