Problems with Camera

Hello and good morning,
hope you can help me with my problem. I use Lightburn and Ruida with the camera, I set up and calibrated everything according to the instructions, the values ​​during calibration were great and were 0.16 to 0.20. The calibration test that followed went really well. When I approached a point via Lightburn afterwards, it was absolutely accurate. Now to the problem, how I wanted to laser next time, I had to set an offset of the X axis of -10 so that I hit the specified point, the Y axis was correct. Do you have any idea why this could be or has someone already had the same problem?

Thanks Marc
Sory for the bad English, it is from Google :smile:

Hello Marc,

Did you try the following:
A few squares all around the working area… and see if they are all off the same?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.