I am current using the demo version of the licence. I have a XTOOL D1 Pro 10w laser. I have followed the online tutorials, which are excellent. I have used the demo project in lesson 2 to create a QR Code for home wifi access. I can recreate the demo project BUT when it is sent to the laser, it is engraved and cut in Mirror image. The online documentation suggests to move the origin from lower left to upper right. This was tried without success. I am looking at an issue that is a characteristic of the demo version of the software.
Check this post:
Make sure you’re adjusting machine origin in Device Settings. And this should be top-left. Note that this is different than Job Origin in Laser window.
Thanks Berainlb. Your fix worked.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.