# RC8, Epilog, macOS

**URL:** <https://forum.lightburnsoftware.com/t/rc8-epilog-macos/193298>\
**Category:** LightBurn Software Questions\
**Tags:** mac, epilog-support\
**Created:** [October 19, 2026, 9:57pm UTC](https://forum.lightburnsoftware.com/t/rc8-epilog-macos/193298 "2026-10-19T21:57:54Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![DanLand](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/d/b5a626/32.png) [@DanLand](https://forum.lightburnsoftware.com/u/DanLand)\
**Post date:** [October 19, 2026, 9:57pm UTC](https://forum.lightburnsoftware.com/t/rc8-epilog-macos/193298/1 "2026-10-19T21:57:55Z")

</div>

Just tried RC8, Still can’t set cut speed greater than 300in/min on an Epilog Fusion Pro48. I should be able to set it to 9921in/min…

Link to previous thread

> [@RC7, Epilog Fusion Pro48](https://forum.lightburnsoftware.com/t/rc7-epilog-fusion-pro48/193211/5):
>
> Sounds good, thank you.

---

<div class="post-metadata">

**Author:** ![DanLand](https://forum.lightburnsoftware.com/letter_avatar_proxy/v4/letter/d/b5a626/32.png) [@DanLand](https://forum.lightburnsoftware.com/u/DanLand)\
**Post date:** [October 20, 2026, 2:08am UTC](https://forum.lightburnsoftware.com/t/rc8-epilog-macos/193298/2 "2026-10-20T02:08:09Z")

</div>

This exists in the public 2.2 release also.

---

<div class="post-metadata">

**Author:** ![system](https://forum.lightburnsoftware.com/user_avatar/forum.lightburnsoftware.com/system/32/64335_2.png) [@system](https://forum.lightburnsoftware.com/u/system)\
**Post date:** [November 19, 2026, 2:08am UTC](https://forum.lightburnsoftware.com/t/rc8-epilog-macos/193298/3 "2026-11-19T02:08:55Z")

</div>

Closed on November 19, 2026, 2:08am UTC

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
